小默

【转】IP checksum definition

IP checksum definition

The IP checksum is the 16 bit one's complement of the one's complement sum of all 16 bit words in the header.

One question many people may ask is "What is the 1's complement sum ?". This is because all computers utilize the 2's complement representation and the 1's complement is not used. The following gives a short introduction.

2's complement fixed point integers (8-bit)

BinaryDecimalHex
0000 0000000
0000 0001101
0000 0010202
0000 0011303
1111 1111-1FF
1111 1110-2FE
1111 1101-3FD

Let's add two intergers: 
-3 + 5 = 2 
FD + 05 = 01 02
Discarding the carry (01) gives the correct result.

1's complement fixed point integers (8-bit)

BinaryDecimalHex
0000 0000000
0000 0001101
0000 0010202
0000 0011303
1111 1111-0FF
1111 1110-1FE
1111 1101-2FD
1111 1100-3FC

Add the same numbers: 
-3 + 5 = 2
FC + 05 = 01 01
Adding the carry (01) to the LSB (01) gives the correct result:
01 + 01 = 02

So, the 1's complement sum is done by summing the numbers and adding the carry (or carries) to the result..

Simple Internet checksum example

Suppose we have an 8-bit, 2's complement, machine and send the packet

FE 05 00

where 00 is the checksum field.

Let's calculate and verify the Internet checksum.

 FE + 05  =  01 03

This is the result of the normal (2's complement) addition. The 1's complement sum requires the addition of the carry to the 8-bit word (even though we will not get the same result)

 03 + 01 = 04  

so the 1's complement sum of FE + 05 is 04.

The 1's complement of the 1's complement sum (Internet checksum) will be 

~04  = FB

and the packet will be sent as

FE 05 FB 

Now, at the receiving end we add all the received bytes, including the checksum (again using the 2's complement representation)

FE + 05 + FB  = 01 FE  

The 1's complement sum is  

 FE + 01 = FF = -0  

which checks that the transmission was OK (see below).

A more complex example (32-bit machine)

As shown in RFC 1071, the checksum calculation is done in the following way:

(1) Adjacent octets to be checksummed are paired to form 16-bit integers, and the 1's complement sum of these 16-bit integers is formed.

(2) To generate a checksum, the checksum field itself is cleared, the 16-bit 1's complement sum is computed over the octets concerned, and the 1's complement of this sum is placed in the checksum field.

(3) To check a checksum, the 1's complement sum is computed over the same set of octets, including the checksum field. If the result is all 1 bits (-0 in 1's complement arithmetic), the check succeeds.

Packet

01 00 F2 03 F4 F5 F6 F7 00 00

(00 00 is the checksum field)

Form the 16-bit words

0100 F203 F4F5 F6F7

Calculate 2's complement sum

0100 + F203 + F4F5 + F6F7 = 0002 DEEF (store the sum in a 32-bit word)

Add the carries (0002) to get the 16-bit 1's complement sum

DEEF + 002 = DEF1

Calculate 1's complement of the 1's complement sum

~DEF1 = 210E

We send the packet including the checksum 21 0E

01 00 F2 03 F4 F5 F6 F7 21 0E

At the receiving

0100 + F203 + F4F5 + F6F7 + 210E = 0002 FFFD
FFFD + 0002 = FFFF

which checks OK.

Comments
It may look awkword to use a 1's complement addition on 2's complement machines. This method however has its own benefits.

Probably the most important is that it is endian independent. Little Endian computers store hex numbers with the LSB last (Intel processors for example). Big Endian computers put the LSB first (IBM mainframes for example). When carry is added to the LSB to form the 1's complement sum (see the example) it doesn't matter if we add 03 + 01 or 01 + 03. The result is the same.

Other benefits include the easiness of checking the transmission and the checksum calculation plus a variety of ways to speed up the calculation by updating only IP fields that have changed.


The IP Header Checksum is computed on the header fields only. 
Before starting the calculation, the checksum fields (octets 11 and 12) 
are made equal to zero. 

In the example code, 
u16 buff[] is an array containing all octets in the header with octets 11 and 12 equal to zero. 
u16 len_ip_header is the length (number of octets) of the header.


/*
**************************************************************************
Function: ip_sum_calc
Description: Calculate the 16 bit IP sum.
***************************************************************************
*/
typedef unsigned short u16;
typedef unsigned long u32;

u16 ip_sum_calc(u16 len_ip_header, u16 buff[])
{
        u16 word16;
        u32 sum=0;
        u16 i;
    
        // make 16 bit words out of every two adjacent 8 bit words in the packet
        // and add them up
        for (i=0;i<len_ip_header;i=i+2){
                word16 =((buff[i]<<8)&0xFF00)+(buff[i+1]&0xFF);
                sum = sum + (u32) word16;
        }

        // take only 16 bits out of the 32 bit sum and add up the carries
        while (sum>>16)
                sum = (sum & 0xFFFF)+(sum >> 16);

        // one's complement the result
        sum = ~sum;

        return ((u16) sum);
}

posted on 2010-10-20 17:05 小默 阅读(662) 评论(0)  编辑 收藏 引用 所属分类: Network


只有注册用户登录后才能发表评论。
网站导航: 博客园   IT新闻   BlogJava   知识库   博问   管理


导航

统计

留言簿(13)

随笔分类(287)

随笔档案(289)

漏洞

搜索

积分与排名

最新评论

阅读排行榜