来自
http://www.cnblogs.com/walzer/archive/2006/04/21/380851.html首先解释下这两个东东
The RAM on a Windows CE–based device is divided into two areas: the object store and the program memory.
The object store resembles a permanent, virtual RAM disk. Data in the object store is retained when you suspend or perform a soft reset operation on the system. Devices typically have a backup power supply for the RAM to preserve data if the main power supply is interrupted temporarily. When operation resumes, the system looks for a previously created object store in RAM and uses it, if one is found. Devices that do not have battery-backed RAM can use the hive-based registry to preserve data during multiple boot processes.
The program memory consists of the remaining RAM. Program memory works like the RAM in personal computers — it stores the heaps and stacks for the applications that are running.
我承认我很懒，上面一段话的URL是ms-help://MS.WindowsCE.500/wcecoreos5/html/wce50conMemoryArchitecture.htm
具体的设置可以在系统启动后，Control Panel -> System -> Memory 里面看到。默认的是把内存五五开，一半给Storage Memory， 一半给Program Memory用。这样显然是不合算的。以64M的RAM为例, 启动后Storage Memory 32M, 而因为没有留出界面让用户往里面拷东西, 任何时候in use都不会超过10M; Program Memory也是32M, 但启动后就用掉27M, 实际上应用程序可用的内存只有5M, 一旦达到了上限, 那么每前进一步都要很艰难地去释放几十K内存，然后用掉，再去释放几十K内存，如此循环，此时应用程序的运行速度狂慢无比.
划分的方法也很简单, 只不过可能没人注意到而已.
说明在ms-help://MS.WindowsCE.500/wceosdev5/html/wce50lrfFSRAMPERCENT.htm 懒得看英文的人就继续往下看
其实说白了就一句话, 在BSP的config.bib里 CONFIG 区添加这个变量 FSRAMPERCENT = 0xXXXXXX, 但注意两点，
(1) 必须写在config.bib的CONFIG区里, 不是plagform.bib不是config.reg等其他文件而是config.bib，也不是config.bib文件的任意地方而一定要在CONFIG REGION里.
(2) FSRAMPERCENT这个变量一定得写为FSRAMPERCENT, 不能写成FSROMPERCENT不能写成ILOVEU, 或者阿猫阿狗什么的.
写下这两句的时候本人已经打开无敌光环, 免疫一切鸡蛋和西红柿.
FSRAMPERCENT是一个4byte长度的十六进制数, 我们用代数假设 FSRAMPERCENT = 0xQXYZ, 其中Q,X,Y,Z都是十六进制数
那么最终划分给Storage Memory的大小 = ( Q + X + Y + Z ) / 0x400 * TOTAL_RAM_SIZE
以文中的例子来算, FSRAMPERCENT=0x10203040, 假设TOTAL_RAM_SIZE=64M, 那么StorageMemory= (0x10 + 0x20 + 0x30 + 0x40) / 0x400 * 64M = 10M.